Connection Status - Pppoe - LevelOne NetCon WBR-3408 User Manual

Connection Status - PPPoE

If using PPPoE (PPP over Ethernet), a screen like the following example will be dis-
played when the "Connection Details" button is clicked.
Data - PPPoE Screen
Connection
Physical Address
IP Address
Network Mask
PPPoE Link Status
Connection Log
Connection Log
Figure 21: PPPoE Status Screen
The hardware address of this device, as seen by remote
devices on the Internet. (This is different to the hardware
address seen by devices on the local LAN.)
The IP Address of this device, as seen by Internet users.
This address is allocated by your ISP (Internet Service
Provider).
The Network Mask associated with the IP Address above.
This indicates whether or not the connection is currently
established.
•
If the connection does not exist, the "Connect" button
can be used to establish a connection.
•
If the connection currently exists, the "Disconnect"
button can be used to break the connection.
•
The Connection Log shows status messages relating to
the existing connection.
•
The most common messages are listed in the table
37
Operation and Status