Lan Screen - LevelOne NetCon WBR-3408 User Manual

LAN Screen

Use the LAN link on the main menu to reach the LAN screen. An example screen is
shown below.
Data - LAN Screen
TCP/IP
IP Address
Subnet Mask
DHCP Server
Figure 6: LAN Screen
IP address for the Wireless Broadband router, as seen from the
local LAN. Use the default value unless the address is already in
use or your LAN is using a different IP address range. In the
latter case, enter an unused IP Address from within the range
used by your LAN.
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Network Mask for the
LAN segment to which the Wireless Broadband router is at-
tached. i.e. the same value as the PCs on that LAN segment.
•
If Enabled, the Wireless Broadband router will allocate IP
Addresses to PCs (DHCP clients) on your LAN when they
start up. The default (and recommended) value is Enabled.
•
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-
configured to treat the Wireless Broadband router as the de-
fault Gateway. See the following section for further details.
•
The Start IP Address and Finish IP Address fields set the
values used by the DHCP server when allocating IP Ad-
dresses to DHCP clients. This range also determines the
number of DHCP clients supported.
•
Enter the desired values for DNS IP Address, Gateway IP
Address and Leased Time, if preferred.
See the following section for further details on using DHCP.
15
Setup