Table of Contents
Advertisement
VPN Broadband Router User Manual
LAN Screen
Use the LAN link on the main menu to reach the LAN screen an example screen is shown below.
Data - LAN Screen
TCP/IP
IP Address
Subnet Mask
DHCP Server
Buttons
Save
Cancel
Figure 7: LAN Screen
IP address for the VPN Broadband Router, as seen from the
local LAN. Use the default value unless the address is already in
use or your LAN is using a different IP address range. In the
latter case, enter an unused IP Address from within the range
used by your LAN.
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the VPN Broadband Router is attached (the
same value as the PCs on that LAN segment).
If Enabled, the VPN Broadband Router will allocate IP Ad-
dresses to PCs (DHCP clients) on your LAN when they start
up. The default (and recommended) value is Enabled.
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-
configured to treat the VPN Broadband Router as the default
Gateway. See the following section for further details.
The Start IP Address and Finish IP Address fields set the
values used by the DHCP server when allocating IP Ad-
dresses to DHCP clients. This range also determines the
number of DHCP clients supported.
See the following section for further details on using DHCP.
Save the data on screen.
The "Cancel" button will discard any data you have entered and
reload the file from the VPN Broadband Router.
14
Advertisement
Table of Contents
