Initial Access To The Network Camera; Check Network Settings - LevelOne FCS-1060 User Manual

For more detailed usage of the Installation Wizard, please refer to the user manual of
the Installation Wizard included in the product CDROM to find the location of the
Network Camera. There may be many Network Cameras in the local network. Users
can differentiate the Network Cameras with the MAC address. The MAC address is
printed on the back of the Network Camera body. Initial Access to the Network Camera

Check Network Settings

FCS-1060/WCS-2060 IP Network Camera can be connected either before or immediately after
software installation onto the Local Area Network. The Administrator should complete the network
settings on the configuration page, including the correct subnet mask and IP address of gateway
and DNS. Ask your network administrator or Internet service provider for the detail information. By
default the Network Camera requires the Administrator to run installation every time it reboots. If
the network settings are to remain unchanged, disable the Install option. Refer to "Network
settings" on the System Configuration page for details. If any setting is entered incorrectly and
cannot proceed to setting up the Network Camera, restore the factory settings following the steps
11