Wireless Station Configuration; Wireless Configuration On Windows Xp - LevelOne WBR-3460 User Manual

Wireless ADSL2/2+ Modem Router User Guide

Wireless Station Configuration

This section applies to all Wireless stations wishing to use the Wireless ADSL2/2+
Modem Router's Access Point, regardless of the operating system which is used on
the client.
To use the Wireless Access Point in the Wireless ADSL2/2+ Modem Router, each
Wireless Station must have compatible settings, as follows:
Mode
SSID (ESSID)
Wireless
Security

Wireless Configuration on Windows XP

If using Windows XP to configure the Wireless interface on your PC, the configuration
procedure is as follows:
1. Open the Network Connections folder. (Start - Settings - Network Connections).
2. Right-click the Wireless Network Connection, check that it is enabled (menu option
says Disable, rather than Enable) and then select View Available Wireless Net-
works.
3. You will then see a list of wireless networks.
The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
This must match the value used on the Wireless ADSL2/2+ Mod-
em Router. The default value is Wireless.
Note! The SSID is case sensitive.
By default, Wireless security on the Wireless ADSL2/2+ Modem
Router is disabled.

If Wireless security remains disabled on the Wireless
ADSL2/2+ Modem Router, all stations must have wireless se-
curity disabled.

If Wireless security is enabled on the Wireless Router (either
WEP or WPA-PSK), each station must use the same settings
as the Wireless ADLS Router.
Figure 26: Network Connections (Windows XP)
40