Wireless Station Configuration - LevelOne WBR-6000 User Manual

4.6 Wireless Station Configuration

This section applies to all Wireless stations wishing to use the
Wireless Broadband Router's Access Point, regardless of the
operating system which is used on the client.
To use the Wireless Access Point in the Wireless Broadband Router,
each Wireless Station must have compatible settings, as follows:
Mode The mode must be set to Infrastructure (rather than
Ad-hoc)
Access points only operate in Infrastructure mode.
This must match the value used on the Wireless
SSID
Broadband Router. The default value is Wireless.
(ESSID)
Note! The SSID is case sensitive.
By default, Wireless security on the Wireless
Wireless
Broadband Router is disabled.
Security
•
•
If Wireless security remains disabled on the
Wireless Broadband Router, all stations must
have wireless security disabled.
If Wireless security is enabled on the Wireless
Router (either WEP or WPA-PSK, WPA2-PSK),
each station must use the same settings as the
Wireless ADLS Router.
49