Pro Setup - Auto-Balance - Ada PTM-6150 Operation & Installation Manual

Pro Setup - Auto-Balance

The Cinema Reference's "Out
Of The Box" Setup has the
Auto Balance in the On
position. You can selectively
set the Auto Balance to On or
Off for Inputs set to a Dolby
mode.
The Cinema Reference also permits you to turn off the Auto Bal-
ance circuit. When the Auto Balance is on, the Cinema Reference
will compensate for discrepancies in the left and right channels, when
in an analog domain. The Cinema Reference's "Out Of The Box"
Setup has the Auto Balance in the On position.
1 While in the Pro Setup mode, turn the MODE knob until the
display reads AUTO BALANCE and then press the MODE
knob. The display will read AUTO BALANCE on the top
line and the second line will read the current scale factor
and the mode name IS NOW ON or IS NOW OFF.
2 Turn the MODE knob to turn the Auto Balance On or Off.
You can turn the INPUT knob to see the settings on other
inputs with other modes.
3 To exit the AUTO BALANCE Setup Mode without leaving the
Pro Setup Mode, press the MODE knob. If you wish to
exit the Setup Mode completely, turn any of the knobs
other than MODE or INPUT.
Page 57