Quick Setup; Initial Preparation; Select Program Number - Ada MB-1 Owner's Manual

ADA MB-1 owners manual version 2
PRECAUTIONS
WARNING:
CAUTION:
RETAIN INSTRUCTIONS:
CLEANING:
QUICK SET -UP
Note: The MB-1 is a preamp and must be connected to a power amp in order to drive loud
speakers.
Note: If you are using the complete ADA Bass Amplification System (MB-1, B500B,
BASSLINE 15, and BASSLINE HX), set all rear panel controls to the points indicated by
white dots.

INITIAL PREPARATION:

1. Connect bass guitar output to front panel input jack.
2. Connect MB-1 output(s) to input(s) on power amplifier(s)
3. Connect power amp output(s) to speaker cabinet(s) input(s), Note: use speaker
cable(s) for this connection.
4. Turn MB-1 power switch ON.
5. Turn power amp on.
6. Adjust volume with Output level control.

SELECT PROGRAM NUMBER:

1. Use the up and down arrow buttons to scroll thru the memory numbers 1 thru79.
These are the Factory Preset Programs.
2. Select a bank by pressing the BANK button, use the up or down arrow button to
select bank 0 thru 7, followed by any button 0 thru 9 for program number within the
selected bank, (1 thru 9 in bank 0).
SELECT MIDI CHANNEL:
1. Press MIDI CHANNEL button.
2. Use up and down arrows to select MIDI channel from 1 to 16, ALL (OMNI), or OFF
(MIDI reception off.)
3. Press MIDI CHANNEL button to store channel selection and exit to play mode.
To prevent fire or shock hazard, do not expose this appliance to rain or
moisture. Keep the MB-1 out of direct sunlight. Avoid locations subject
to vibration, excessive dust, heat, or cold.
To prevent electric shock, do not remove cover. No user serviceable
parts inside. Refer servicing to qualified service personnel.
Keep this manual for future reference.
Do not clean your MB-1 with chemical solvents. Use only a
clean, dry cloth.
Page 4 of 22