Brewer Cleaning; Cleaning Sprayhead; Inspecting Sprayhead Seal; Cleaning & Maintenance - Bunn My Cafe Single Cup Use & Care Manual

CLEANING & MAINTENANCE
Rinse the Drawer(s) after each use. Drawers, Drip Tray and Drip Tray Cover are top rack
dishwasher safe. Occasionally wipe outside of the brewer, including the Drip Tray and Drip
Tray Cover, with a mild, no citrus added dish soap and a damp cloth.
Clean your brewer at least every 3 months. Mineral deposits may accumulate due to
impurities in the water used to brew. If deposits are not removed, they can impair the
operation of the brewer and reduce product life. The frequency of internal system cleaning
depends on the mineral of your water (the higher the mineral content, the more often you
should perform brewer maintenance).
Insert any Drawer.
1.
Open Spin Lid on top of brewer.
2.
Fill Pour-in Bowl with 14 oz. white vinegar.
3.
Close Spin Lid.
4.
Place empty cup (greater than 14 oz.) on
5.
the Travel Mug Base or Drip Tray Cover.
Mineral deposits and loose coffee or tea granules may clog the Sprayhead, causing the brew
cycle to slow.
Unplug the brewer and allow it to cool
1.
(minimum 1 hour).
Remove Drawer.
2.
Facing the brewer, rotate the Sprayhead
3.
clockwise (using your fingers) until the
Sprayhead and Seal are removed.
Clean Sprayhead and Seal with mild
4.
detergent and rinse thoroughly.
A toothpick may also be used to clear
debris from Sprayhead holes.
When disassembling your brewer for cleaning, inspect the Sprayhead Seal for cracks, tears
and holes. Although the Seal should last for an extended period of time, damage can occur
through handling.
CAUTION: To prevent injury from hot water, do not use the unit if the Seal is damaged.
If damaged, call Customer Service at 800-352-2866 or visit www.BunnAtHome.com to
obtain a replacement Seal.

brewer cleaning

cleaning the sprayhead
inspecting the sprayhead seal
Push Brew Button to cycle vinegar
6.
through brewer.
Run three or more additional 14 oz. cycles
7.
of water through brewer to flush remain-
ing vinegar from brewer.
Follow the steps below to clean
8.
the Sprayhead.
CAUTION: If the Sprayhead and
Sprayhead Seal are separated,
they must be reassembled. Improper
reassembly could result in injury from
scalding water
Replace Sprayhead. rotate the Sprayhead,
5.
counter-clockwise until finger tight.
Replace Drawer.
6.
Plug in brewer to restore power.
7.
10