Mechanical Instructions - Philips 107E7 Service Manual

17" CDT Color Monitor

6. Mechanical Instructions

0. General
To be able to perform measurements and repairs on the "circuit boards", these unit should be placed
in the service position first.
1. Remove the rear cover
Remove 3 screws as shown in Fig. 1 and Fig. 2
2. Video board
Cut the tip on the front frame as show in Fig. 3
Disconnect the adhesive tape and ground pins
between metal shield of Video board and main
board as shown in Fig. 4 to Fig. 7
Cut the tie between the CRT neck and the video
board as shown in Fig. 8
Fig. 4
Fig. 1
Fig. 5
25
Fig. 2
Fig. 3
Fig. 6
107E7