Table of Contents
Advertisement
Mechanical Instructions
Ea
| 16 |
Mechanical Instructions
4
Go to cover page
t€4 Go to cover page
4. Main panei with Bottom Tray
-Remove
2 screws
for disconnect the Bottom tray as Fig. 5
-Pull the bottom tray on press right and left side clip from fig. 6
ta fig. 7
Q. General
To be able to perform measurements and repairs on the "circuit
boards", these unit should placed in the service position first.
1.Remove the rear cover in Fig. 1.
-Remove 2 screws as shown
-Remove back cover as shown
-Remove pedestal as shown
5. SERVICE POSITION
Reconnect connectors, some wires and panels (chassis),
service position can be available for DC/AC measurement
as shown in Fig. 8
2. Video panel
+ Disconnect the wire between metal shield of Video panei and
CRT neck as shown in Fig. 2.
- Disconnect the CRT ground from Video panel.
- Remove screw grounding and grounding wire in Fig. 3.
3.Main board connector in Fig. 4
-Disconnect york wire
-Disconnect rotation connector
-Disconnect control board connector
-Remove Screw for fixed I/F cable
-Remove signal connector
-Remove degaussing wire connector
=amzzzs>
Fig. 7
Pull-up
screw - grounding
Fig. 3
Clip
Fig. 5
Screw
Pedestal ass'y
Screw
Screw
Fig.1
Degaussing wire connector
Video panel
Main panel
Control connector
Signal connector
Rotation connector
Fig. 8 SERVICE POSITION
Press CLIP
Fig. 4
CRT grouding wirel
Video Panel
u
Fig. 2
Advertisement
Table of Contents
