0. General
To be able to perform measurements and repairs on the "circuit
boards", these unit should placed in the service position first.
1.Remove the rear cover
-Remove right and left lib (screw cover) on the back cover
as shown in Fig. 1.
-Remove 4 screws as shown in Fig. 2.
-Remove back cover as shown in Fig. 3.
2. Remove pedestal as shown in Fig. 4.
3. Video panel
- Disconnect the wire between metal shield of Video panel and
CRT neck as shown in Fig. 5.
- Disconnect the CRT ground "1703" from Video panel.
Mechanical Instructions
screw
screw
Video Panel
M32 107E4 GS_3
15
Go to cover page
lids (screw cover)
Fig. 1
screw
Fig. 2
screw
Fig. 3
Rear cover
Pedestal ass'y
Fig. 4
Fig. 5