Wall Control Installation - Ferroli VTP 15 Installation Manual

INSTALLATION

WALL CONTROL INSTALLATION

First it is necessary to choose where to install the remote control; according to the size and the length of the
connections, arrange a raceway suitable for holding the connection cables or a special junction box . The figure
below shows the dimensions of the control .
To secure the remote control, remove the front part, carefully remove the electronic board inside (fixed with screws to
the rest of the structure) and fix the control by means of two screws, as shown in the figures below .
When installing the remote control, pay special attention to the direction in which it is fixed; make sure the plate is
oriented correctly before securing the anchor screws .
Remember the maximum length of the connection cable is 8 m .
Do not install the remote controller in a place where it could come into direct contact with flows of water or large
amounts of steam .
Connection with wall control
The wall control must be connected to the unit's control board using the special power cable supplied . The connection
must be made to the connector inside the unit's panel:
- disconnect the panel
- connect the cable of the control to the cable on the unit
- close the panel
Fig . 5
14