Connecting Other Video Equipment; Other Antenna Connections; Other Antenna Connection To The Unit; Other Antenna Connection From The Unit To The Television - Panasonic DMR-E30 Operating Instructions Manual

Home Theater

Connecting other video equipment

Connecting to the L2 input terminals on the front
of the unit
/ I
POWER
yellow white red
§
S video cable
Audio/Video
cable (included)
yellow white red
L R
VIDEO
S VIDEO
OUT AUDIO
OUT
OUT
Other video equipment
Connect to the video and audio output terminals.
§
By using the S video cable instead of the yellow video cable you
may make recordings of higher picture quality.
[Note]
≥If the audio output of the other equipment is monaural, connect to
L/MONO. (Both left and right channels are recorded when con-
nected through L/MONO.)
48
RQT6559
!?
Connecting to the input terminals on the rear of
the unit, L1 and L3
(L1)
R - AUDIO - L VIDEO S-VIDEO R - AUDIO - L
OPTICAL
DIGITAL AUDIO OUT
R - AUDIO - L VIDEO S-VIDEO R - AUDIO - L
(PCM/BIT STREAM) (L3)
red white yellow
§
S video cable
Audio/Video cable
(included)
red white yellow
R L
S VIDEO
AUDIO VIDEO
OUT
OUT OUT
Other video equipment
Connect to the video and audio output terminals.
§
By using the S video cable instead of the yellow video cable you
may make recordings of higher picture quality.
[Note]
≥If audio output on the other equipment is monaural, use a stereo-
monaural conversion cable (not included).

Other antenna connections

Other antenna connection to the unit

Use one of the following connections to suit the antenna lead.
∫ A single twin lead
300–75 ≠ transformer
(not included)
from the antenna
To this unit's
RF IN terminal
(Flat)
Twin lead
300 ≠ cable
∫ A twin lead and a coaxial cable
from the antenna
VHF/UHF band mixer
(Flat)
(not included)
Twin lead
300 ≠ cable
(Round)
75 ≠ coaxial cable
To this unit's
RF IN terminal
∫ Two twin leads
from the antenna
300–75 ≠ transformer
(not included)
(Flat)
Twin lead
300 ≠ cable
VHF/UHF band mixer
(not included)
To this unit's
RF IN terminal
≥If your television has both lead and coaxial VHF terminals, use the
lead connection to minimize signal loss.
Other antenna connection from the unit
to the television
Use one of the following connections to suit the antenna terminals
on your television. Refer to the television's operating instructions.
∫ A twin lead and coaxial plug terminal
Television
VHF
VHF/UHF band separator
(not included)
UHF
75 ≠ coaxial cable
∫ A twin lead terminal
Television
75–300 ≠ transformer
VHF or
(not included) UHF
75 ≠ coaxial cable
∫ Two twin lead terminals
Television
VHF
VHF/UHF band separator
(not included)
UHF
75 ≠ coaxial cable
∫ Multiple antenna terminals
Television
Split out
ANT 1
75 ≠ coaxial cable
ANT 2
≥Connect to one of the terminals, then change the television's set-
ting as necessary.
49
RQT6559