Advertisement
HF multi-mode transceiver KN920 operation manual (MCU v02.02)
Ensure that the current state of the MEM, ie, the first character of the first
line of LCD is M;Ensure that the current does not hide the menu parameter
adjustment of status, that is no longer the right side of the second line of
LCD digital strings.
Read from the channel frequency
In some cases, the need to adjust the reception frequency stored in the
frequency down to a channel in the vicinity of such channel is stored in a
7.050MHz, and now have to work 7.053MHz, which requires the frequency of the
channel status read channel VFO in the past. Operation should be carried out as
follows:
In MEM mode, select the channel to be read, press the DIS button repeatedly,
the second line of the LCD display is adjusted to the character shown below:
Then press the F4 key, the current state of the channel and frequency have been
read out, and automatically switch to the VFO state, you can rotate the main
dial to adjust the frequency of the received frequency.
Switching work mode
KN920 in LSB, USB, CW, AM, FM mode, these types of work, and you can switch back and
forth, to switch to a working model, you need to follow the following steps:
Repeatedly press the DIS button to adjust the second line of the LCD display characters shown
below:
Then press the F1 key, the mode will switch between the LSB and USB, press F2,
operating mode will switch to CW, press F3, operating mode will be switched to
AM, press F4, operating mode will switch to FM.
KN920 now live mode appears on the LCD at the last character in the first line
of each mode is shown below:
Ham radio products www.bh3mde.com
Email:bh3mde@hotmail.com
- 6 -14
Advertisement
