Switching Channels - Ham radio KN920 Operation Manual

HF multi-mode transceiver KN920 operation manual (MCU v02.02)
Then press the F1 key, the first line of the LCD will display the first
character is M.
Then rotate the main frequency knob to adjust to the need to store the channel,
and then press the F1 key to switch back to VFO state, and finally press the F4
key, the current frequency is stored to the desired channel storage.

Switching channels

Stored in the channel more content, you can switch channels to listen to a
desired program and signals.To switch to a different channel, you need to
switch to MEM KN920 state, if not the MEM status, you can repeatedly press the
DIS button to adjust the second line of the LCD display characters shown below:
Then press the F1 key, the first line of the LCD will display the first
character is M, ie, channel status.
At this time the main frequency by turning the knob you can change channels,
listen to the specified signal.
If the rotary knob does not change the main frequency channel, please check the
following items:
Ensure that the main frequency knob is not locked, ie, the first character of
the second line of LCD does not display a small key symbol;
Ham radio products www.bh3mde.com
Email:bh3mde@hotmail.com
- 5 -14