Multi Duct; Main Pwb; Dispenser; Display Pwb Replacement - Kenmore Elite 795.71082.01 series Service Manual

3-7 MULTI DUCT

1. Remove the upper and
lower Caps by using a
flat screwdriver, and
remove 2 screws.
(Figure 17)
2. Disconnect the lead wire
on the bottom position.

3-8 MAIN PWB

1) Loosen the 4 screws on the PWB cover.
2) Remove the PWB cover
3) Disconnect wire harness and replace the main PWB in
the reverse order of removal.

3-9 DISPENSER

1) Disconnect funnel and
button assembly by
pulling down and
forward.
2) Hold the left and right side
of the "Cover Assembly,
dispenser" as shown in the
picture, and pull and
remove it. The cover
dispenser is attached with a
hook.
CAUTION : When replacing the dispenser cover in the
reverse order of removal, be careful that the lead wire
Figure 17 does not come out and the water tube is not pinched by
the dispenser cover, as shown in the picture below.

3-10 DISPLAY PWB REPLACEMENT

1) Pull up and out on the dispenser cover to remove.
2) Follow the steps in the pictures

3-11 FUNNEL REPLACEMENT

1) Pull up and out on the dispenser cover to remove.
2) Disconnect the wire harness.
3) Replace in reverse order.
- 10 -