Kenmore Elite 795.71082.01 series Service Manual page 30

8-1-5 Ultra Ice selection
Please select this function for quick freezing.
• Function is repeat Ultra Ice Icon whenever pressing Ultra Ice button.
• Ultra Ice function automatically turns off after a fixed time passes.
8-1-6 Dispenser use selection
You can select water or ice.
Select water, crushed ice, or ice cubes by cycling through the selections
when pressing the DISPENSER button,
Hold your cup in the dispenser for a few seconds after dispensing ice or
water to allow the last pieoes of ice or drops of water to fall into the cup.
When after initially establ ishing the water comes out, the water tank inside
fills and until at the time of quality the hour is caught.
8-1-7 DISPENSER LIGHT
- Whenever pressed the LIGHT button, DISPLAY is changed as belows.
Normal status : When dispenser is operated, DISPENSER LIGHT is ON.
AUTO status : Detecting the lighting of room by LIGHT SENSOR, DISPENSER LIGHT is on and off automatically.
ON status : DISPENSER LIGHT is on continuously.
8-1-8 CONTROL OF FREEZER FAN MOTOR
1. Freezer fan motor has high and standard speeds.
2. High speed is used at power-up, for Ultra Ice, and when refrigerator is overloaded.
Standard speeds is used for general purposes.
3. To improve cooling speed, the RPM of the freezer fan motor change from normal speed to high.
4. High speed (2700RPM) : Initial power on or load corresponding operation, Ultra Ice.
Normal speed (2400RPM) : General working conditions.
5. Fan motor stops when refrigerator or freezer door opens.
8-1-9 Cooling Fan Motor
1. The cooling fan is switched ON and OFF in conjunction with the compressor.
2. The cooling fan Motor has high and standard speeds. (When room temper rapture more high then 38 °C speed is high)
3. The Failure sensing method is the same as in the fan motor of the freezing fan motor(refer to failure diagnosis function
table for failure display).
8-1-10 Ice Compartment Fan
1. The Icing Fan is controlled by the the sensor on the top of the ice compartment.
2. The Failure sensing method is the same as in the fan motor of the freezer
(refer to failure diagnosis function table for failure display)
- 30 -
Pressing
Switch