Three-Party Conference - Panasonic KX-HDV130 Operating Instructions Manual

Sip phone
Hide thumbs Also See for KX-HDV130:
Table of Contents

Advertisement

number to retrieve a parked call. The feature depends on your phone system. Contact your administrator
for further information.
To set
1.
Park
To retrieve (Call Park Retrieve)
[In standby mode]
1. Enter the Call Park Retrieve feature number.
2. Go off-hook.
Note
R Depending on the telephone system, the
call. In this case, you can retrieve the call by pressing the blinking
a parked call using the soft key, the Call Park Retrieve feature number must be set beforehand.
Contact your administrator for further information.
Talking to Two Parties Alternately (Call Splitting)
When talking to one party while the other party is on hold, you can swap the calls back and forth
(alternately).
To alternate between the parties leaving one party on hold temporarily
1. Press
/
2. Dial the other party's extension number.
3. After talking to the other party, press
4. Talk to the original party.

Three-party Conference

During a conversation, you can add an additional party to your call and establish a conference call.
Note
R Your phone system may support advanced conference features, such as conference calls with four or
more parties. In this case, the procedures for handling a conference call may be different from those
explained in this section. For details, contact your phone system dealer/service provider.
Making a Conference Call
1. Press
/[CONF] during a conversation.
2. Dial the party you want to add to the conversation. a
3.
/[CONF]
Removing a Party from the Conference
During a conference, you can remove other parties from the conference. However, this operation is
available only during conference calls you initiate.
1. During a conference call, press
2. Press the corresponding
3. Go on-hook.
4. Go off-hook. a
*1 When a program key is assigned as a Line key, this feature is available.
Park
/[HOLD/MESSAGE] during a conversation.
/
/[LINE] key for the party you want to disconnect.
/
/[HOLD/MESSAGE]
soft key might blink to show that the line has a parked
/
/[HOLD/MESSAGE].
Call
/[HOLD/MESSAGE].
During a Conversation
soft key. However, to retrieve
Park
*1
a
OK
33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents