6. Fill the engine with the appropriate amount and type of engine oil. Refer to Capacities - Approximate
Fluid and Fluid and Lubricant Recommendations in Maintenance and Lubrication.
7. Run the engine for 3 minutes.
8. Raise the vehicle.
9. Thoroughly inspect the oil filter and the oil pan drain plug areas for leaks.
10. Allow the engine to cool for a minimum of 3 minutes.
11. Lower the vehicle.
12. Check the engine oil level.
13. Top-off the engine oil to the full mark on the oil level indicator (dipstick), if necessary.
14. Install the oil fill cap.
15. Close the hood.
16. Reset the engine oil life monitor. Refer to GM Oil Life System - Resetting in Maintenance and
Lubrication.
DRAINING FLUIDS AND OIL FILTER REMOVAL
Tools Required
J 41712 Oil Pressure Switch Socket