Crankshaft Rear Oil Seal Replacement - Chevrolet 5.7L Corvette 2004 Shop Manual

13. Use the J 41478 in order to install the oil seal into the cover bore.
Use a wrench and hold the hex on the installer bolt.
Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
Remove the tool.
Inspect the oil seal for proper installation. The oil seal should be installed evenly and completely
into the front cover bore.
14. Install the water pump. Refer to Water Pump Replacement in Engine Cooling.
15. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .

CRANKSHAFT REAR OIL SEAL REPLACEMENT

Tools Required
J 41479 Crankshaft Rear Oil Seal Installer
Removal Procedure