System Log - D-Link DGS-1100-16 Reference Manual

The fields that can be configured are described below:
Parameter
Host IPv4 Address
UDP Port
Facility
Severity
Click the Apply button to accept the changes made.

System Log

This window is used to view and clear the system log.
To view the following window, click System > System Log > System Log, as shown below:
Click the Clear Log button to clear the system log entries displayed in the table.
Enter a page number and click the Go button to navigate to a specific page when multiple pages
exist.
Description
Enter the system log server's IPv4 address here.
Enter the system log server's UDP port number here. This
value must be between 1024 and 65535. By default, this
value is 514.
Specifies an application from which system logs are sent to
the remote server. Only one facility can be assigned to a
single server. If a second facility level is assigned, the first
facility is overwritten. There are up to eight facilities can be
assigned (Local 0 to Local 7).
Select the severity value of the type of information that will be
logged. Options to choose from are Warning, informational,
and All
The possible levels are:
Warning - The lowest level of a device warning. The device
is functioning, but an operational problem has occurred.
Informational - Provides device information.
All - Displays all levels of system logs.
Figure 5-12 System Log window
2 2 7
D-Link DGS-1100 Series Switch User Manual
7