13. Save And Tools; Save Configuration; Firmware Information; Firmware Upgrade & Backup - D-Link DGS-1100-16 Reference Manual

13. Save and Tools

Save Configuration

Firmware Upgrade & Backup
Configuration Restore & Backup
Log Backup
Ping
Reset
Reboot System
Save Configuration
This window is used to save the running configuration to the start-up configuration of the Switch.
This is to prevent the loss of configuration in the event of a power failure.
To view the following window, click Save > Save Configuration, as shown below:
Click the Apply button to save the configuration to the switch's flash memory.

Firmware Information

This window is used to show firmware information.
To view the following window, click Tools > Firmware Information, as shown below:
Boot Up: Clicking the Boot Up button will set that firmware image as the active image to use upon
the next system start up.
Note: Changing the firmware only happens after the switch has been manually rebooted. In order to
boot with the newly selected firmware, make sure that the switch is rebooted.
Firmware Upgrade & Backup
Figure 13-1 Save Configuration window
Figure 13-2 Firmware Information window
Note: When upgrading the firmware on the DGS-1100 Series switch, only the image
not currently active can be upgraded. All DGS-1100 Series switches come with two
images, however only one can be active at any time. (e.g. If image 1 is currently in use,
only image 2 can be upgraded, and vice versa.)
Note: If the switch is in HTTPS mode, the firmware or configuration cannot be
upgraded using regular HTTP.
D-Link DGS-1100 Series Switch User Manual
7 7 2 2