Table of Contents
Advertisement
M-AX10
9. PANEL FACILITIES AND SPECIFICATIONS
FRONT SECTION
1
1 POWER
Press to switch the appliance on and off.
2 OPERATION MODE
Use this to switch between the three modes:
bridge,dual and separate. Be sure to turn the
power off before switching between modes.
Switching with the power on will activate the
warning circuit. The mode illumination light
and mode indicator will flash, and the output
will be muted.
If it happens, you should turn the operation
mode switch back to its original position.
The flashing will stop, and your M-AX10 will
return to normal.
3 ATT HOLD
This button is activated only if the OPERATION
MODE switch is pointing to SEPARATE.
Press the ATT HOLD (attenuator hold) button
while in separate mode allows whatever atten-
uation has been set with the ATTENUATOR
knob to be retained.
Pressing it again will cancel the operation.
Note,however, that it is not possible to turn
ATT HOLD on and off while the output is muted
(eight seconds after switching the power on).
58
~
-
9
0
8
3
2
4
4 ATT THROUGH
BEWARE: If this button is used ,the volume
will be herted at maximum level.
Pressing the ATT THROUGH button for two
seconds or longer causes the sound to be
output through the speakers without passing
through the attenuator circuit. However, because
the mute circuit is activated, thereis no sound
for five seconds after the button is depressed.
The sound will emerge from the speakers
five seconds after the ATT THROUGH button
is pressed. Note that it will be maximaum volume.
Pressing the button again will cancel the operation.
5 ILLUMINATION
Pressing the ILLUMINATION button once, twice or
three times alters the brightness of the panel light,
mode indicator as indicated below.
Pressing it a fourth time will return the lights to
their initial settings.
initial
setting
Press
once
Press
twice
Press
three
times
=
5
6
Mode
Panel
illumination
light
light
Bright
On
Dim
On
Off
On
Off
Off
7
Mode
indicator
On
On
On
Off
Advertisement
Table of Contents
