Table of Contents
Advertisement
8. PANEL FACILITIES AND SPECIFICATIONS
8.1 PANEL FACILITIES
1
2
5
1 Power switch (POWER —OFF/_ON)
Press the power switch to turn the amplifier on and off.
2 DISPLAY OFF indicator
This indicator turns on when the display is turned off by
the Brightness Selection button (-).
3 Remote control sensor
Point the remote control towards this sensor when op-
erating the amplifier.
4 Display
5 INPUT SELECTOR
This is used to select the input signal.
6 SOUND MEMORY jog dial
You can save and recall up to 16 tone control setting
patterns and 8 speaker setup patterns and change the
memory number display.
7 Front flip-down door
Press lightly on the bottom of this door to open it.
8 MULTI CONTROL jog dial
This jog dial is used to make various settings.
Turn the dial to select the setting, and then press to
enter (ENTER/NEXT). Refer to the page of the specific
function for more details.
3
6
7
4
9 MASTER VOLUME knob
This knob is used to adjust the volume. Turning this
knob adjusts the volume for all channels simulta-
neously.
0 2/DTS button
When this mode is selected, Dolby Digital, Dolby Pro
Logic, or DTS Surround Mode is turned on automati-
cally according to the input signal.
- Brightness Selection button (DIMMER)
The display brightness can be adjusted to four levels
including Display Off.
When Display Off is selected, the Display Off indicator
(2) turns on.
= DVD Input Selector button
(DVD INPUT 2 ch/multi ch)
When DVD-A input is selected, this button is used to
choose either two-channel input or multichannel (six
channel) input.
~ Sampling Frequency Selector button (fs 96k/48k)
When an analogue input signal is output from the digi-
tal output jack (DIGITAL OUT), this button is used to
select whether the sampling frequency (fs) remains un-
modified at 96 kHz or drops down to 48 kHz.
! DIGITAL NR button
This button is used to select the Digital NR function
mode.
@ Hi-bit button
This button is used to turn the Hi-bit function on and off.
# MIDNIGHT button
This button turns the Midnight function on and off.
$ DIRECT button
This button is used to select the Direct function mode.
C-AX10
DOLBY
D I G I T A L
8
9
113
Advertisement
Table of Contents
