Panel Facilities And Specifications - Pioneer VSA-E03 Service Manual

VSA-E03

8. PANEL FACILITIES AND SPECIFICATIONS

8.1 PANEL FACILITIES
Front Section
2 3
1
AUDIO/VIDEO MUL TI-CHANNEL AMPLIFIER
ST ANDBY
ST ANDBY/ON
CHANNEL
–
LEVEL
– -
OFF ON
PHONES
#
$
1 Main power switch (— OFF, _ ON)
2
STANDBY/ON button
Press to switch the amplifier on or put in standby.
3 STANDBY indicator
Lights when the amplifier is in standby mode. (Please
note that this amplifier consumes a small amount of
power (1 W) during the standby mode.)
4 CHANNEL SELECT button
Use to select a speaker when ajusting speaker levels.
5 SPEAKERS (A/B) buttons
Use to switch the corresponding speaker system on
or off. To listen to both speaker systems (A and B),
press the buttons so that both A and B appear in the
display. Only A speakers are available when using
surround sound modes.
6 BASS (–/+) button
Press to adjust low frequencies in the range of ±6.
7 Display
8 TREBLE (–/+) button
Used to adjust high frequencies in the range of ±6.
9 LOUDNESS button
Switches the loudness on or off. Use to raise the level
of the bass and treble so they can be more easily
heard when listening at low volumes.
0 Remote sensor
Point the remote control toward the remote sensor to
operate the amplifier.
56
4 5 6
N∫z¿x?≤
CHANNEL
+
SELECT
SPEAKERS B ASS
–
A B
VCR D VD/LD TV/SA T VIDEO
D VD 5.1CH
7 8 9 0 - = ~ !
SIGNAL
MIDNIGHT
SELECT
TREBLE
–
+ +
DIRECT
LOUDNESS
CD TUNER MD/T APE A UX
%
-
(Dolby) Surround button
Press to select the
mode automatically switches between Dolby Digital
and Dolby Pro Logic decoding according to the input
signal.
= SIGNAL SELECT button
Use to select input signals for the digital components.
First press VCR, DVD/LD, TV/SAT, CD or MD/TAPE (%,
Function buttons) to select the component, then press
SIGNAL SELECT repeatedly to select one of the
following:
ANALOG : Selects the analog (R and L) audio signals.
DIGITAL : Selects the digital audio signals. This
amplifier automatically detects and displays the
format of the signal being input. AC-3 lights when
Dolby Digital signals are input. (AC-3 decoding is
switched automatically.)
• SIGNAL SELECT is fixed in the "ANALOG" position
for components not assigned to one of the three
digital input jacks.
• Because the audio from a karaoke microphone and
LD recorded with analog audio only is not output
from the digital output, set SIGNAL SELECT to
"ANALOG".
• This amplifier can only play back Dolby Digital,
PCM (32kHz, 44kHz, and 48kHz) signal formats. With
digital signal formats other than these, set SIGNAL
SELECT to "ANALOG".
@
MASTER
V OLUME
DSP
MODE
DO WN UP
VIDEO INPUT
L A UDIO R
S-VIDEO VIDEO
^
&
(Dolby) Surround mode. This