Yamaha YFM4FAR Service Manual page 95

CHANGING THE COOLANT
CAUTION:
Adding water instead of coolant lowers
G
the antifreeze content of the coolant. If
water is used instead of coolant, check,
and if necessary, correct the antifreeze
concentration of the coolant.
Use only distilled water. However, soft
G
water may be used if distilled water is not
available.
If coolant comes into contact with painted
G
surfaces, immediately wash them with
water.
Do not mix different types of antifreeze.
G
13.Install:
Radiator cap
G
14.Fill:
Coolant reservoir
G
(with the recommended coolant to the
maximum level mark a)
15.Install:
Coolant reservoir cap
G
16.Start the engine, warm it up for several
minutes, and then turn it off.
17.Check:
Coolant level
G
Refer to "CHECKING THE COOLANT
LEVEL".
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
18.Install:
Left footrest board
G
Refer to "FOOTREST BOARDS".
Front fender
G
Engine skid plate
G
Front carrier
G
Engine side cover
G
Fuel tank side panel (left)
G
Seat
G
Refer to "SEAT, CARRIERS, FENDERS
AND FUEL TANK".
3 - 32
CHK
ADJ