STEERING SYSTEM
REMOVING THE STEERING KNUCKLES
1.Remove:
Steering knuckle 1
G
NOTE:
Use a general puller to separate the ball joints
2 from the steering knuckle 1 or the front
lower arm 3.
CHECKING THE TIE RODS
1.Check:
Tie rod free play and movement
G
Free play → Replace the tie rod end.
Turns roughly → Replace the tie rod end.
2.Check:
Tie rods
G
Bends/damage → Replace.
G
CHECKING THE STEERING KNUCKLES
1.Check:
Steering knuckles
G
Damage/pitting → Replace.
2.Check:
Ball joints
G
Damage/pitting → Replace the ball joint.
Free play → Replace the ball joint.
Turns roughly → Replace the ball joint.
*****************************************************
Replacement steps:
G
Clean the outside of the steering knuckle.
G
Remove the steering knuckle oil seal.
Remove the circlip 1 and rubber boot 2.
G
Use the ball joint remover and installer set.
8 - 36
CHAS