Closing The Cover And Connecting Cables - Lenovo ThinkCentre 8098 Hardware Maintenance Manual

Closing the cover and connecting cables

After replacing the hardware, you need to install any removed parts, replace the
cover, and reconnect any cables, including telephone lines and power cords. Also,
depending on the FRU that was replaced, you might need to confirm the updated
information in the Setup Utility program.
1. Ensure that all components have been reassembled correctly and that no tools
2. Make sure that the cables are routed correctly before lowering the drive bay
3. Lower the drive bay assembly and position the drive locks to the locked
4. Close and latch the cover.
5. If a cover lock is installed, lock the cover.
6. If your computer is being placed in the vertical position, attach the floor stand.
7. Reconnect the external cables and power cords to the computer. See "Locating
8. Turn on the computer. To update the configuration, see Chapter 6, "Using the
9. If you have replaced the system board, you must update (flash) the BIOS. See
or loose screws are left inside your computer.
assembly.
position. Otherwise, you cannot close the cover.
Attention: To prevent overheating and possible component damage, always
attach the floor stand when placing the computer in the vertical position.
connectors on the rear of the computer" on page 138.
Setup Utility," on page 55.
"Flash update procedures" on page 338.
Chapter 10. Replacing FRUs (Types 8098, 8171, 8172, 8173, 8424, and 8425)
159