Closing The Cover And Connecting Cables - Lenovo THINKCENTRE 8084 Hardware Maintenance Manual

10. If the front bezel was removed, replace it by aligning the four plastic tabs and
11. Reconnect the signal and power cables to the drive.
12. Go to "Closing the cover and connecting cables."

Closing the cover and connecting cables

After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the Setup Utility program.
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
3. Position the cover on the chassis so that the guides on the top and bottom of
4. Reconnect the external cables and power cords to the computer.
5. To update the configuration, see Chapter 6, "Using the Setup Utility," on page
Note: When the power cord is first plugged in, the computer might appear to turn
104
Hardware Maintenance Manual
Note: This illustration shows a CD drive installation. The hard disk drive and
diskette drive is installed in the same manner except that the front
bezel is not in place.
9. If installing the hard disk drive, replace the cover on the front of the drive.
pressing the bezel into position.
or loose screws are left inside the computer.
the cover engage the chassis and push the cover to the closed position. Insert
the screws that secure the cover.
55.
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.