Inserting The Sealing Tape / Adjusting The Sealing Tape Width - Pfaff 8303-040 Instruction Manual

Setting up
9

Inserting the sealing tape / adjusting the sealing tape width

.01.03
Machines without sealing tape trimmer
Machines with sealing tape trimmer
9 - 2
Requirement
The sealing tape should run in the centre of the feed rollers and be guided in a narrow
channel but still run easily through the guide.
Fig. 9 - 03
Switch off the machine and let it cool down!
Danger of burns on contact with the hot air nozzle!
Cut the sealing tape at a slant for easier insertion.
Insert the sealing tape into guide 1 and pull it through up to the feed rollers.
Adjust guide pins 2 (screws 3) in accordance with the requirement.
Cut the sealing tape at a slant and insert it as far as possible into guide 4.
Switch on the machine and operate the sealing tape feed key, until the sealing tape
becomes visible, see Chapter 7.06 Sealing tape feed key.
Trigger off a cutting operation, see Chapter 7.08 Machine head keys and pedals.
Remove the protective cover and adjust the guide with screw 5 in accordance with the
requirement.
Switch off the machine and attach the protective cover.
If the sealing tape is pulled in at a crooked angle or if it gets caught in the
sealing tape trimmer, switch off the machine and draw the sealing tape
through with tweezers.
Danger of injury when the machine is switched on!
4
2
5
1
3