Toshiba RAV-SM404SDT-E Service Manual page 168

12-4-4. Others
1. Selection of LED display (SW800, SW803 operation)
1) Display selection list
The displayed contents of LED D800 to D804 on the outdoor control P .C. board can be exchanged by
operation of SW803.
Switch
SW803
SW803
TD TE
SW803 SW803
TO TL
SW803 SW803
TA TC
SW803 SW803
SW803
SW803
SW803
Error display (Error generating at present)
Error generating at present is displayed.
This switch goes off when an error does not generate.
Error display (The latest error: Latest error including present)
After error status was cleared, the error which generated before
can be confirmed by this setting. (Reconfirmation is available
even if power supply was turned off once.)
• If an error generates at present, the same contents as those of
error which is generating at present are displayed.
• Only error of TO sensor is not displayed by this setting.
(Confirm it by setting of error which is generating at present.)
Temperature sensor display
TS
SW803
The detected value of temperature sensor is displayed.
TH
SW803
TCJ
SW803
Current display
The current value which flows in the outdoor unit is displayed.
Compressor operation frequency display
The operation frequency of the compressor is displayed.
PMV opening display
The opening of PMV (Pulse Motor Valve) is displayed.
Function / Contents
– 168 –
<In case of SP110, SP140>
Refer
Refer to
Page 169.
Refer to
Page 169.
Refer to
Page 170.
Refer to
Page 170.
Refer to
Page 170.
Refer to
Page 170.