Rear Bench Seat - Mercedes-Benz Sprinter Operator's Manual

Folding seat (example with partition sliding door)
Remove key : from the partition sliding
X
door.
Pull grip ; of the catch in the direction of
X
the arrow and fold seat cushion = up or
down.
Release grip ; of seat cushion = in the
X
corresponding end position.
Move the seat cushion = until it engages.
X
Grip ; of the catch must lie completely on
the seat frame.
Rear bench seat (Passenger Vans)
G
WARNING
If the rear bench seat is not installed as
described or an unsuitable rear bench seat is
installed, the seat belts may not provide
protection as intended. There is an increased
risk of injury.
Install the rear bench seat as described. Only
use rear bench seats that are approved for
your vehicle by the distributor named on the
inside cover page.
! For safety reasons, the four-seat rear
bench must only be removed or installed at
a qualified specialist workshop.
Keep the seat bench mounting recesses in
the vehicle floor free from dirt and foreign
objects.
Locking mechanism lever on the feet of the bench
seat
To remove the rear bench seat: swing all
X
levers : of the bench seat completely
upwards.
The bench seat moves back into the seat
mounting recesses on the vehicle floor.
Lift the bench seat upwards out of the seat
X
mounting recesses.
i
Do not exceed the maximum permissible
number of seats for models registered as
passenger vehicles.
To install the rear bench seat: observe
X
the prescribed installation position of the
bench seat.
Install the two-seat bench seat only on the
driver's side.
Check mounting shells ; on the vehicle
X
floor.
Mounting shells ; must be free from dirt
and foreign objects.
Position the bench seat in the direction of
X
travel in corresponding mounting
shells ;.
Seats
83
Z