Paint - Mercedes-Benz Sprinter Operator's Manual

When using the vehicle in winter, remove all
traces of road salt deposits carefully and as
soon as possible.
High-pressure cleaning equipment
G WARNING
The water jet from a circular jet nozzle (dirt
blasters) can cause invisible exterior damage
to the tires or chassis components.
Components damaged in this way may fail
unexpectedly. There is a risk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced
immediately.
! Observe the minimum distance to be
maintained between the nozzle of the
power washer and object to be cleaned, as
outlined below:
approximately 2.2 ft(70 cm) when using
R
round-jet nozzles
approximately 1 ft (30 cm) when using
R
25°flat-spray jets and dirt blasters
Keep the water jet moving while cleaning.
To avoid causing damage, do not point the
water jet directly at:
door joints
R
brake hoses
R
electrical components
R
electrical connections
R
seals
R
drive train, especially not at the
R
intermediate bearing of the propeller
shaft
rear view camera (camera lens and
R
microphone opening on the bottom)
Keep a minimum distance of
1.6 ft(50 cm).
Cleaning the engine
! Water must not enter intake or ventilation
openings. When cleaning with high
pressure water or steam cleaners, the
spray must not be aimed directly at
electrical components or the terminals of
electrical lines.
Preserve the engine after the engine has
been cleaned. Protect the belt drive system
from exposure to the preservative agent.
Also observe the information in the section
"Power washer" ( page 257).
Y
Cleaning the paintwork
! Do not affix:
stickers
R
films
R
magnetic plates or similar items
R
to painted surfaces. You could otherwise
damage the paintwork.
Scratches, corrosive deposits, areas affected
by corrosion and damage caused by
inadequate care cannot always be completely
repaired. In such cases, visit a qualified
specialist workshop.
Remove impurities immediately, where
X
possible, whilst avoiding rubbing too hard.
Soak insect remains with insect remover
X
and rinse off the treated areas afterwards.
Soak bird droppings with water and rinse
X
off the treated areas afterwards.
Remove coolant, brake fluid, tree resin,
X
oils, fuels and greases by rubbing gently
with a cloth soaked in petroleum ether or
lighter fluid.
Use tar remover to remove tar stains.
X
Use silicone remover to remove wax.
X
Cleaning the windows
G
WARNING
You could become trapped by the windshield
wipers if they start moving while cleaning the
windshield or wiper blades. There is a risk of
injury.
Always switch off the windshield wipers and
the ignition before cleaning the windshield or
wiper blades.
Care
257
Z