Paint - Mercedes-Benz S-Class Coupe Operator's Manual

Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced imme-
diately.
!
Always maintain a distance of at least 11.8in
(30cm) between the vehicle and the high-
pressure cleaner nozzle. Information about
the correct distance is available from the
equipment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
Do not aim directly at any of the following:
tires
R
door gaps, joints etc.
R
soft top (Cabriolet)
R
wind deflector net (Cabriolet)
R
electrical components
R
battery
R
connectors
R
lights
R
seals
R
trim elements
R
ventilation slots
R
Damaged seals or electrical components can
lead to leaks or failures.
!
Always maintain a distance of at least
11.8 in (30 cm) between the vehicle and the
power washer nozzle. Information about the
correct distance is available from the equip-
ment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
Do not aim directly at any of the following:
tires
R
door gaps, roof gaps, joints, etc.
R
electrical components
R
battery
R
connectors
R
lights
R
seals
R
trim
R
ventilation slots
R
Damaged seals or electrical components can
lead to leaks or failures.
!
If the SmartKey is within the rear detection
range of KEYLESS-GO, the following situa-
tions, for example, could lead to the uninten-
tional opening of the trunk:
using a car wash
R
using a power washer
R
Make sure that the SmartKey is at least 10 ft
(3 m) away from the vehicle.
Cleaning the paintwork
!
Do not affix:
stickers
R
films
R
magnetic plates or similar items
R
to painted surfaces. You could otherwise
damage the paintwork.
Scratches, corrosive deposits, areas affected by
corrosion and damage caused by inadequate
care cannot always be completely repaired. In
such cases, visit a qualified specialist workshop.
Remove dirt immediately, where possible,
X
while avoiding rubbing too hard.
Soak insect remains with insect remover and
X
rinse off the treated areas afterwards.
Soak bird droppings with water and rinse off
X
the treated areas afterwards.
Remove coolant, brake fluid, tree resin, oils,
X
fuels and greases by rubbing gently with a
cloth soaked in petroleum ether or lighter
fluid.
Use tar remover to remove tar stains.
X
Use silicone remover to remove wax.
X
If water no longer forms "beads" on the paint
surface, use the paint care products recommen-
ded and approved by Mercedes-Benz. This is the
case approximately every three to five months,
depending on the climate conditions and the
care product used.
If dirt has penetrated the paint surface or if the
paint has become dull, the paint cleaner recom-
mended and approved by Mercedes-Benz
should be used.
Do not use these care products in the sun or on
the hood while the hood is hot.
Use a suitable touch-up stick, e.g. MB Touch-
X
Up Stick, to repair slight damage to the paint-
work quickly and provisionally.
Care
297
Z