Superior DRT2033 Installation And Operation Instructions Manual page 56

Innovative Hearth Products
Superior™ DRT2000 and DRC2000 Direct-Vent Gas Fireplaces
Installing the glass door
1. Visually inspect the gasket on the backside of the glass door.
2. Position the door in front of the firebox opening with the bottom of the door held away from the fireplace at a
3. Let the bottom of the glass door swing gently in towards the fireplace ensuring that the gasket seats evenly as
4. Install the barrier.
5. Close the control compartment door.
Removing the glass door
1. Open the control compartment door (Page 50).
2. Remove the barrier. Place the barrier in a safe location for later reinstallation.
3. Detach the two (2) door latches beneath the firebox floor.
4. Swing the bottom of the glass door away from the fireplace to a 45° angle (Figure 58)
5. Carefully grip the door at the top and bottom, and remove it from the fireplace. Place the door in a safe location
Figure 58: Glass Door
56
NOTE: The gasket surface must be clean, free of irregularities, and seated firmly. Ensure it is properly located.
Make sure the bead is not rolled into the channel at the top of the door, but remains flat against the top of
the glass.
45° angle (Figure 58). Hook the top flange of the door frame over the top of the firebox frame.
NOTE: Ensure the glass door is centered—with even spacing on each side.
the door draws shut. Securely fasten the two (2) latches beneath the firebox floor to the door V-flange.
NOTE: If necessary, remove the door and place it in a safe location for later reinstallation.
for later reinstallation.
Glass
Door
Control
Compartment
Door
Hood
Latch
Operation
900004-00, 04/2014