Table of Contents
Advertisement
Figure 14. Installing a memory module
8. Reinstall all parts that have been removed.
9. Go to "Completing the parts replacement" on page 57.
Installing or replacing the optical drive
Attention
Do not open your server or attempt any repair before reading and understanding the Chapter 1 "About this
manual" on page 1 and the Safety Information book. To obtain a copy of the Safety Information book,
go to:http://www.lenovo.com/support
This section provides instructions on how to install or replace the optical drive.
To install or replace an optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 30.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 31.
4. Depending on whether you are installing or replacing an optical drive, do one of the following:
• If you are installing a secondary optical drive, remove the plastic panel in the front bezel for the
drive bay you want to use. If there is a metal static shield installed in the drive bay, remove the
metal static shield.
• If you are replacing an optical drive, disconnect the signal cable and the power cable from the
rear of the optical drive, press the blue release button
the optical drive bay.
38
ThinkServerHardware Maintenance Manual
1
, and then slide the optical drive out of
Advertisement
Table of Contents
