Derbi Dirtboy 10 Workshop Manual page 11

M M MAINTENANCE
M A I N T E NA N CE
Fill up the engine with the recommended oil, using the filler
hole on the RHS engine cover.
Tighten the cap manually.
N.B.
LET THE ENGINE RUN FOR A FEW MINUTES, THEN
CHECK THE OIL LEVEL AGAIN, WITH THE ENGINE COLD;
THIS MUST ALWAYS BE AT THE LOWER EDGE OF THE
INSPECTION HOLE.
N.B.
WHEN REPLENISHING FOR THE FIRST TIME, OR AFTER
AN OVERHAUL, POUR IN 600 CC OF ENGINE OIL. IN ALL
OTHER CASES USE 550 CC AND IF NECESSARY TOP UP.
Recommended products
AGIP CITY 4 T
Synthetic oil 20W40
C
C
The oil level must be at the lower edge of the filler cap.
Therefore, before starting the «cold» engine, it is necessary
to check the oil level using the inspection hole on the RHS
engine cover.
C
HARACTERISTIC
Engine oil
Capaciity: ~ 600c.c.
CHECKING TIMING PHASE CHECKING TIMING PHASE
Turn the magnetic flywheel in a clockwise direction until the
mark on it is lined up with the reference mark on the Pick-
up/Stator bracket, as shown in the figure, always bearing in
mind that the mark on the magnetic flywheel is the reference
for the first magnet (in a clockwise direction).
11