Microswitch (Door Handle Assembly); Inner Door; Shell - Midea WQP6-3305E series Technical Service Manual

Microswitch (door handle assembly)

The microswitch connects a forceful electric power. All loads of the dishwasher are
series connection with microswitch. When the microswitch closes, the dishwasher
machine is stopped.
Removal and Replacement
1. Disconnect power supply.
2. Remove outer door assembly. (see outer door removal and installation)
3. Pull out microswitch (door handle assembly). Then pull out all terminals of microswitch (door
handle assembly)
Terminals
4. Reverse the above procedure to install. And check out all connectors connects well.

Inner Door

Caution
: Inner door of edges are sharp.
Removal and Replacement
1. Remove outer door assembly. (see outer door
removal and installation)
2. Pull out all terminals of dispenser and microswitch
(include some locking terminals). (see dispenser
removal and replacement, and microswitch (door
handle assembly) removal and replacement)
3. Remove all screws for fixing inner door.
4. Remove dispenser. (see dispenser removal and replacement)
5. Remove door handle assembly. (see door handle assembly removal and replacement)
6. Reverse the above procedure to install. And check out all connectors connects well.

Shell

Removal and Installation
1. Take off cutlery basket, basket and filter system.
2. Remove all screws for fixing shell with tank assembly in the front of dishwasher machine.
Screws
3. Remove all screws for fixing shell with backboard and bottom board in the rear of
dishwasher machine.
Screws