Table of Contents
Advertisement
Clamps
5.
Reverse the above procedure to install.
Pressure switch
As the dishwasher basin fills with water, the air pressure in the
switch hose increases. When the pressure reaches the aim of
switch will act and give a signal to main control board. Then
will be work.
Removal and Replacement
1.
Remove shell. (see shell removal and installation)
2.
Take out two corner boards, absorber sound,
backboard, hollow plate.
3.
Unfix the sheet copper for fixing the pressure switch hose.
Part name: 1 – sheet copper 2 – pressure switch hose 3 – pressure switch
4.
Unfix the snap-fit of bottom board for
fixing pressure switch. And pull out
pressure
switch
terminals of pressure switch
Note: mark all terminals' colors and
positions.
5.
Reverse the above procedure to install.
And check out all connectors connects
well.
Tank assembly
hose.
Pull
out
all
1
2
3
pressure
value, the
the
drain
Snap-fits
of bottom
board
Locking
terminals
Hide quick links:
Advertisement
Table of Contents
