Connecting To Web-Based Interface - D-Link DIR-620 User Manual

DIR-620 Wireless N300 Router with 3G/CDMA/LTE Support
and USB Port
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.).
Start a web browser (see the Before You Begin section, page 17). In the address bar of the web
browser, enter the IP address of the router (by default, the following IP address is specified:
192.168.0.1). Press the Enter key.
Figure 16. Connecting to the web-based interface of the DIR-620 device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
After the first access to the web-based interface you need to change the default administrator
password. Enter the new password in the Password and Confirmation fields. You may set any
password except admin. Use digits, Latin letters (uppercase and/or lowercase), and characters
available on the keyboard. Then click the Apply button.
Figure 17. The page for changing the default administrator password.
Remember or write down the new password for the administrator account. In case of losing
!
the new password, you can access the settings of the router only after restoring the factory
default settings via the hardware RESET button. This procedure wipes out all settings that
you have configured for your router.
Page 31 of 225
Installation and Connection