Pppoe + Static Ip Connection - D-Link DIR-620 User Manual

DIR-620 Wireless N300 Router with 3G/CDMA/LTE Support
and USB Port
User Manual

PPPoE + Static IP Connection

Fill in the IP Address and Netmask fields.
In the Gateway IP address field, enter the IP address of the gateway used by this WAN
connection.
In the Primary DNS server field, enter the address of the primary DNS server.
If your wired ISP uses authorization via the 802.1x protocol, in the Authorization via 802.1x
protocol section, select the Authorization in the ISP's network via 802.1x protocol
checkbox and fill in the fields of the section in accordance with data provided by your ISP.
As a rule, the specified settings are enough at this step to configure a connection of the selected
type. If you need to specify additional settings, open the expert settings mode. To do this, use the
switch in the bottom left corner of the page (for a detailed description of all the connection's
parameters, see the Creating PPPoE + Static IP or PPPoE + Dynamic IP WAN Connection
section, page 107).
Click the Next button to continue.
Figure 33. Configuring PPPoE + Static IP WAN connection.
Page 52 of 225
Configuring via Web-based Interface