Sanyo VCC-9400P Instruction Manual page 26

CAMERA SETTINGS
• • • •
B/W mode setting
1
In the MAIN MENU, select SET for CAMERA and press the
ENTER button.
The CAMERA SETTING screen will appear.
2
Use the joystick lever (j or l) to select SET for LENS,
then press the ENTER button.
The LENS screen will appear.
ENTER
3
Use the joystick lever (j or l) to move the cursor to
DAY/NIGHT, use the joystick lever (d or c) to select the
level setting (example: B/W) and then press the ENTER
button.
The D/N SETTING – B/W screen will appear, and the "+6dB"
setting for "AGC MAX GAIN" will be blinking.
1
Sets the maximum AGC gain.
2
Sets the digital noise reduction.
3
Sets burst suppression. If other peripheral devices (such
as a multiplexer) are connected to the system, bursts
(distortion of image color) can occur when switching
between color and black & white. If this happens, change
the BURST setting to "ON".
4
Sets the focus when switching to black & white mode.
English
CAMERA SETTING
SYNC INT
PRIVACY MASK SET
LENS SET
VIEW SETTING 1
LENS
PRESET OFF
MENU END
FOCUS MANU ‚
ZOOM SET
DAY/NIGHT AUTO ‚
VIEW ANGLE OFF
PRESET OFF
MENU BACK
D/N SETTING - B/W
AGC MAX GAIN +6·
DNR OFF
BURST OFF
FOCUS 1
PRESET OFF
MENU BACK
AGC MAX GAIN setting
4
Use the joystick lever (j or l) to move the cursor to
AGC MAX GAIN, and then use the joystick lever (d or c)
to select the gain.
Available settings: Select the maximum AGC gain from
‚
‚
‚
Note:
• • • •
If "OFF" is selected, no maximum gain will be set.
• • • •
If "OFF" is selected, the SENSE UP function will be forcibly set
to "OFF". However, the setting display will not change.
‚
DNR setting
5
Use the joystick lever (j or l) to move the cursor to
DNR, and then use the joystick lever (d or c) to select
the digital noise reduction setting (example: ON).
Available settings:
• • • •
ON: DNR (digital noise reduction) is applied. This reduces
1
2 interference at low luminance levels.
• • • •
3
OFF: DNR is not applied.
4
Note:
• • • •
Digital noise reduction operates when the gain control
increases. In addition, blurring and ghosting of images can
occur when moving images are being monitored, and so the
resolution is also reduced slightly.
• • • •
If AGC MAX GAIN is set to "OFF", DNR will be forcibly set to
"OFF".
BURST setting
6
Use the joystick lever (j or l) to move the cursor to
BURST, and then use the joystick lever (d or c) to select
the burst setting (example: ON).
Available settings:
• • • •
ON: The color burst signal is turned on.
• • • •
OFF: This should normally be set to "OFF".
25 –
–
D/N SETTING - B/W
AGC MAX GAIN
DNR
BURST
FOCUS
OFF, –6dB, ±0dB, +6dB, +9dB, +12dB or
+15dB.
D/N SETTING - B/W
AGC MAX GAIN
DNR
BURST
FOCUS
D/N SETTING - B/W
AGC MAX GAIN
DNR
BURST
FOCUS
+6·
OFF
OFF
1
+6·
ON
OFF
1
+6·
ON
ON
1