Loading A Disc; Manually Ejecting A Disc; Using The Dvd Function - Lenovo ThinkPad 40Y8626 User Manual

Loading a disc

1. Press the Eject button. The tray slides out of the drive.
2. Place a disc in the tray with the label facing up.
3. Close the tray by gently pushing the tray in until it latches.

Manually ejecting a disc

If you press the Eject button and the tray does not slide out, turn off the computer
and straighten a large paper clip to form a tool, as shown in the illustration. The
straightened end must extend at least 45 mm (1.8 in.). Insert the extended end into
the manual-eject hole on the front of the drive. Push the paper clip until the tray
opens. Gently pull out the tray until you can remove the disc.

Using the DVD function

To use the DVD function, you need to set up your computer as follows after
installing the CD-RW/DVD Combo II into the Ultrabay Slim drive bay:
1. Enable the DMA setting (Windows XP and Windows 2000 users only).
2. Install WinDVD (the DVD movie player program).
Note: The DVD movie player is supported by Windows 2000 and later versions.
Attention: Do not use force or insert foreign objects to open the tray. If your tray does not
open when you press the Eject button, see "Manually ejecting a disc" for more information.
You can check which version of Windows 2000 you are using by doing the
following:
1. Click Start, move the cursor to Settings, and then click Control Panel.
2. Double-click System.
Read the numbers under "System".
v 4.00.950B means that your version is Windows 2000 OSR2.0 or OSR2.1.
45 mm
1.8 in
Chapter 2. Using the CD-RW/DVD Combo II Ultrabay Slim Drive
2-3