Checking Scanner Driver Operation - Fujitsu fi-6140 Getting Started

2.4 Checking Scanner Driver
Operation
This section explains how to check the operation of the
installed scanner driver by using ScandAll PRO.
Make sure that the scanner driver is installed properly,
following the procedure below.
1. Load the document on the scanner.
For information about how to load the document, refer
to section "2.2 Loading Documents on the ADF for
Scanning" in "fi-6140/fi-6240/fi-6130/fi-6230
Operator's Guide."
2. Launch ScandAll PRO.
From the [start] menu, select [All Programs]
[Fujitsu ScandAll PRO]
3. In ScandAll PRO, select [Tool] on the menu, and
then select [Preferences].
⇒
The [Setup] dialog box appears.
4. On the [Scan] tab, select a driver.
To check the operation of FUJITSU TWAIN 32, select
[TWAIN].
To check the operation of FUJITSU ISIS, select [ISIS].
5. Click the [OK] button to close the [Setup] dialog
box.
6. In ScandAll PRO, select [Scan] on the menu, and
then select [Select Scanner].
[Fujitsu ScandAll PRO].
7. Select a scanner in the displayed dialog box.
To use FUJITSU TWAIN 32:
Select [FUJITSU fi-6140dj], [FUJITSU fi-6240dj],
[FUJITSU fi-6130dj], or [FUJITSU fi-6230dj], and
then click the [Select] button.
To use FUJITSU ISIS:
Select [Fujitsu fi-6140], [Fujitsu fi-6240],
[Fujitsu fi-6130], or [Fujitsu fi-6230], and then click
the [Select] button.
8. Select [Scan] on the menu, and then select [Scan
Settings].
9. In the [Scan Settings] dialog box, clear the [Save to
file] checkbox.
You only check the operation now, so you do not have to
save to file.
10