Table of Contents
Advertisement
3
Connecting the display
The ZM series monitors largely use industry standard cables, which can be purchased pre-
terminated in a variety of lengths. The following chapter provides additional detail where
cables require field termination by the installer.
Rear connections
Key
1
2
3
4
5
6
7
8
¼ Note:
Protection). Sources such as protected DVDs may not display correctly/at all on this monitor.
Cable retention
Cables fitted to the display should utilize some
form of strain relief. All displays are supplied with a
retention bracket, which should be attached to the
rear case.
With the cable and plug fitted in place, secure the cable to the retention bracket using a cable
tie. Do not secure in such a way that applies strain to the cable, or causes the plug or socket
to be bent out of alignment.
1
2
Connection
Function
HDMI-1
Video input (digital)
DVI-2
Video input (digital)
VIDEO-3
Video input for camera (composite - analogue)
VIDEO-4
Video input for camera (composite - analogue)
NMEA2K
Control input/output, software upgrade
SERIAL
Control input/output for touchscreen
USB
Control input/output for touchscreen
POWER
12/24 V DC power supply input
HDMI-1, and DVI-2 inputs do not support HDCP (High bandwidth Digital Content
!
Warning:
Make sure power is switched off before commencing with installation.
3
4
5
6
Connecting the display |
ZM Series User Manual
7
8
| 7
Advertisement
Table of Contents
