Table of Contents
Advertisement
8
16 |
Cleaning and maintenance |
Cleaning and maintenance
If the display requires cleaning, use a damp soft cloth (e.g. microfiber) with a mild, non-
abrasive glass cleaner. Ensure cloth is regularly washed or replaced.
¼ Note:
Do not use paper products as they may scratch the surface. To minimize the risk of
abrasion, allow the screen to air dry.
¼ Note:
Never use acidic, ammonia based, or abrasive cleaning products to clean the display.
These products will damage special coatings on the glass.
¼ Note:
To prevent damage caused by lightning strikes, it is recommended to disconnect the
display from the power source during intense storms, or when the product is not in use for
extended periods.
Display removal
The display's top and bottom bezel trim
must be removed in order to undo the
fasteners holding unit in place by the
mounting flange. The bezel trim have
been designed to be very low profile, and
therefore fully conceal the locking tabs
that keep them from being accidentally
disengaged from the mounting flange. To
release the locking tab, it is necessary to
gently lever the centre of the bezel trim
away from the mounting flange. To remove
the cover, simultaneously slide it sideways;
to the right for the top cover, and to the left
for the bottom cover.
Replacing the gasket
The foam gasket on the rear of the display bezel is available as an optional accessory, should
the factory installed item be damaged.
¼ Note:
take care not to stretch gasket when applying. Only pull gasket minimum amount
required to lay it on straight. The backing paper on outside of gasket will help prevent stretch,
and should only be removed when display is ready to install in to dashboard.
ZM Series User Manual
The mounting brackets should be loosened
in reverse order to fitting. To remove the
brackets, depress the locking tab before
sliding brackets upwards.
Fit the two lengths of foam gasket in to the
rebated channel on the back of the displays
mounting flange. Only remove backing
paper from the side to be stuck to monitor,
and only remove a small amount at a time.
Ensure the gasket ends of the two halves
overlap and make contact.
Advertisement
Table of Contents
