Advertisement
Important : To avoid damage to the meter,
– remove the probes from the item being measured before you change the function settings,
– never try to measure voltages which may exceed 600V or 600Vrms,
– and never try to measure voltages when the meter is set to the resistance measuring function (Ω).
Always use the fuses specified.
To avoid the risk of fire, you should only use fuses of the correct types of the voltage and current ratings specified on the
bottom of the meter.
It is strictly forbidden for "repaired" fuses to be used or for the fuse holders to be shorted out.
WARNING: Read this operating manual thoroughly before you use the meter and follow the instructions given in it when
you are using the meter.
Misunderstandings of the warnings given or the operating instructions and errors in following them may cause hazards or
serious injury and/or may result in damage to the meter or other equipment.
4
Advertisement
