Setting Up + Installation - Baumatic BWMI1262DN1 Instructions For Use Manual

SETTING UP + INSTALLATION

1
2
3
WARNING:
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL
SOURCE OF DANGER.
SOURCE OF DANGER.
Apply the insulation sheet of corrugated material to the base as shown.
Apply the insulation sheet of corrugated material to the base
Type 1
as shown.
Use the 4 feet to level the machine with the floor:
a) Turn the nut clockwise to release the screw adjuster on the foot.
b) Rotate the foot to raise or lower it until it stands firmly on the
ground.
Use the 4 feet to level the machine with the floor:
c) Lock the foot in position by turning the nut
a) Turn the nut clockwise to release the screw adjuster on the foot.
anti-clockwise until it comes up against the bottom of the machine.
b) Rotate the foot to raise or lower it until it stands firmly on the
ground.
c) Lock the foot in position by turning the nut
anti-clockwise until it comes up against the bottom of the machine.
Remove the polystyrene base and place the machine near
its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of
the appliance (diagram 2).
Remove the 2 or 4 fixing screws marked (A) and remove the
2 or 4 spacers marked (B) (diagram 3).
Cover the 2 or 4 holes using the caps provided in the
instruction booklet pack (diagram 4).
4
Type 2
27
A
A
B
B
C
C