devention Scout X4 Quick Start Manual And Systems Flowchart page 7

11.0 DEVO F12E Radio function setup and operation instructions
Function Switch Transmitter setting Instructions
AUTO
Take Off
RUDD D/R
Model Menu
`i
Device Output
Flap
RUDD D/R
Active
Place aircraft on level ground -0.- Unlock Motors
Move throttle stick Set MIX switch
to lowest position to "0" Position
Set RUDD D/R switch to "1" Position
IMPORTANT:
ONLY use this function with BLUE TRIPLE blink = 8 or more
satelites, AUTO take off with less satelites may result in a crash.
AFTER completing auto-take-off, you can take control by moving
the throttle stick to 50%, then flip the RUDD D/R switch to "0" position.
GPS hold
mode
MIX SW
Model Menu
Device Output
Gear
MIX SW
Active
"0" position: Manual mode "1" position: GPS hold mode
"2" position: Return To Home
MIX to "1" Throttle switch position -iii. stick return neutral
NEVER use this mode with less than 8 satelites locked, you should
see BLUE TRIPLE BLINK.
Before switching mode, always put the throttle stick to middle
position ( 50% ).
IF the GPS signal degrades, the X4 will automatically enter "Altitude
hold mode" note in this mode it will drift, but will hold its altitude.
After flying 50% of the battery, do NOT switch from GPS mode to
Manual, this may cause a sudden drop / crash.
You can land in GPS mode, after landing, keep the throttle stick
DOWN and switch to manual, then lock the motors.
Round Fly
Mode
FMOD
Model Menu
`
Device Output
AUX3
FMOD SW
'I'
Active
"0" Position: OFF "1" Position: Not in use
"2" Position: activate Round Fly
This mode require 8 satelites locked, you should see
BLUE TRIPLE BLINK.
Before activating the round-fly mode, you should be in "GPS hold
mode" always put the throttle stick to middle position ( 50% )
The default roundfly radius is 5 meters (15 feet), You can change the
Round Fly radius by editing the AUX 3 EPA (End Point Adjustment)
on the F12E transmitter, for details on editing EPA settings, see the
F12E instruction manual.
After having changed the setting, you should turn FMOD switch to "0"
position to save the data, then return to "2" position to read the new
Roundly radius.
Return TO
Home
MIX SW
Model Menu
Device Output
Gear
`i
MIX
SW
Active
"0" position: Manual mode "1" position: GPS hold mode
"2" position: Return To Home
Throttle MIX to "2" stick return neutral -ir. switch position
The Return To Home mode, only work when you have a solid GPS
lock, it is recommend to avoid flying if GPS lock is missing.
After engaging Return to Home mode, lave the throttle stick at
50% (centered) do not touch any switches on the F12E radio.
You can REGAIN control of the Scout X4, make sure the throttle is
centered, then flip the MIX switch to "1" position. in a emergency like
loss of control link between the F12e and the Scout X4, the Failsafe
system will automatically start RTH, you may not be able to interupt
a emergency RTH, simply let the aircraft continue until it lands.
• 6